Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Suburban K2500, 6.0 U >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 8.1L - Introduction) >> Repair Instructions >> Engine Coolant Temperature (ECT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
    Fig 1: View Of Ignition Coil, ECT And MAP Sensor Electrical Connectors
    GM750529Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system to a level below the engine coolant temperature (ECT) sensor. Refer to Draining and Filling Cooling System in Engine Cooling.
  2. Disconnect the ECT sensor electrical connector (3).
    3. Fig 2: Removing/Installing ECT Sensor Electrical Connector At Oil Fill Tube Bracket
    GM858201Courtesy of GENERAL MOTORS CORP.
  3. Remove the ECT sensor electrical connector from the oil fill tube bracket.
    4. Fig 3: Removing/Installing ECT Sensor
    GM858203Courtesy of GENERAL MOTORS CORP.
  4. Remove the ECT sensor.
scientia non olet · About Mike's Workshop Manuals