Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Body Front End) >> Repair Instructions >> Engine Dash Insulator Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Dash Insulator
    GM897790Courtesy of GENERAL MOTORS CORP.
  1. Touch-up the paint, if required, at the cut line. Refer to Basecoat/Clearcoat Paint Systems in Paint/Coating.
  2. Cut the front of dash insulator at the brake booster, if required.
  3. Position the insulator to the dash.
  4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Install the insulator by pulling down from the underside of the vehicle.
  6. Lower the vehicle.
  7. Install the retainers to the front of dash insulator.
scientia non olet · About Mike's Workshop Manuals