Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Monte Carlo LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.4L - Introduction (2 Of 2) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Valve Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of EGR Valve
    GM507392Courtesy of GENERAL MOTORS CORP.
  1. Install a new EGR valve gasket.
  2. Install the EGR valve.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the EGR valve bolts.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  4. Install the EGR pipe to the EGR valve.
  5. Install the EGR pipe.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  6. Connect the EGR valve electrical connector.
scientia non olet · About Mike's Workshop Manuals