Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 945 (Hybrid Engine Control System) >> Diagnostic Information and Procedures >> DTC P0AFA >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool Hybrid System Voltage parameter in the SGCM data list. The voltage should be greater than 22 volts. If the parameter displays less than the specified value, refer to SGCM 36 volt Output Terminal Circuit Low in Circuit/System Testing .
  2. Ignition ON, observe the scan tool Hybrid System Voltage parameter in the BECM data list. The voltage should be greater than 22 volts. If the parameter displays less than the specified value, refer to Hybrid Battery Pack Voltage Low in Circuit/System Testing .
scientia non olet · About Mike's Workshop Manuals