Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Impala SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.8L (L36 And L67) - Introduction (2 Of 2) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank pressure sensor (7) from the fuel sender assembly (1).
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  3. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
scientia non olet · About Mike's Workshop Manuals