Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Impala SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.8L (L36 And L67) - Introduction (2 Of 2) >> Repair Instructions >> Boost Control Solenoid Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing/Installing Boost Control Solenoid
    GM66407Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67) in Engine Mechanical - 3.8L.
  2. Disconnect the boost source and signal hoses from the boost control solenoid (2).
  3. Disconnect the boost control solenoid electrical connector.
  4. Remove the boost control solenoid nut.
  5. Remove the boost control solenoid (2).
scientia non olet · About Mike's Workshop Manuals