Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 3.4L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAP Sensor
    GM54360Courtesy of GENERAL MOTORS CORP.
  1. Position the MAP sensor to the bracket.
  2. Install the inlet vacuum hose to the MAP sensor.
  3. Connect the MAP sensor electrical connector.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the MAP sensor screws.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

scientia non olet · About Mike's Workshop Manuals