Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 3.4L - Introduction (2 Of 2)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Air Cleaner Intake Duct Components
    GM811623Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the intake air temperature (IAT) sensor electrical connector (3).
  2. Carefully grasp the sensor and with a twisting and pulling motion, remove the IAT sensor (1) from the air cleaner intake duct.
scientia non olet · About Mike's Workshop Manuals