Removal Procedure

Turn the ignition switch to the OFF position.
Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (7.0L) in Engine Electrical.
Drain the coolant system. Refer to Draining and Filling Cooling System (Static Fill) in Engine Cooling.
Remove the fuel injector sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical 6.0L..
Remove the air inlet duct. Refer to Air Cleaner Assembly Replacement in Engine Controls 6.0L..
Disconnect the upper radiator hose. Refer to Radiator Hose Replacement - Inlet in Engine Cooling.

Fig 1: View Of Surge Tank Inlet Hose

Courtesy of GENERAL MOTORS CORP.

Disconnect the surge tank inlet hose. Refer to Surge Tank Hose/Pipe Replacement - Inlet in Engine Cooling.
Position both hoses aside in order to gain access.
Remove the belt tensioner.
- For the accessory drive belt tensioner, refer to Drive Belt Tensioner Replacement - Accessory in Engine Mechanical 6.0L.
- For the a/c drive belt tensioner, refer to Drive Belt Tensioner Replacement - Air Conditioning in Engine Mechanical 6.0L.

Fig 2: View Of Brake Fluid Pressure Sensor Connector & Nuts

Courtesy of GENERAL MOTORS CORP.

Disconnect the brake fluid pressure sensor connector.
Loosen the two insulator nuts located on each side of the brake pressure modulator valve (BPMV).

Fig 3: View Of Master Cylinder

Courtesy of GENERAL MOTORS CORP.

Disconnect and plug the brake pipes that enter the BPMV from the master cylinder (1).

Fig 4: View Of Brake Pipe Locations

Courtesy of GENERAL MOTORS CORP.

Disconnect and plug the brake pipes that enter the BPMV from the front and rear calipers, noting their locations (1).
Disconnect the electronic brake control module (EBCM) connector.
Remove the BPMV/EBCM.