Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Cobalt SS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.2L - (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exploded View Of Throttle Body
    GM782280Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  2. Remove the throttle body. Refer to Throttle Body Assembly Replacement .
  3. Disconnect the manifold absolute pressure (MAP) sensor harness connector.
  4. Remove the MAP sensor (2) from the intake manifold.
    5. IMPORTANT: If the MAP sensor seal is damaged, the MAP sensor must be replaced.
  5. Inspect the seal for damage.
scientia non olet · About Mike's Workshop Manuals