Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View of Knock Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: The KS threaded surfaces must be clean before installation.

Install the knock sensor.
Tighten: Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).
Connect the knock sensor harness connector.
Install the starter. Refer to Starter Motor Replacement (2.2L (L61)) or Starter Motor Replacement (2.0L (LSJ)) in Engine Electrical.