Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Cobalt SS >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Replacement (2.0L - LSJ) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Generator
    GM1381708Courtesy of GENERAL MOTORS CORP.
  1. Position the generator on the engine.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the generator bolts.

    Tighten:  Tighten the generator bolts to 25 N.m (18 lb ft).

  3. Connect the positive battery harness to the generator battery terminal.

    Tighten:  Tighten the generator terminal nut to 20 N.m (15 lb ft).

  4. Connect the generator harness connectors.
  5. Position the oil level indicator tube into the correct installed position and install the retaining bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  6. Install the supercharger. Refer to Supercharger Replacement in Engine Mechanical - 2.0L (LSJ).
  7. Install the drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 2.0L (LSJ).
  8. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About Mike's Workshop Manuals