Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Classic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Transmission Mount Replacement - Front >> Installation Procedure

Installation Procedure

    Fig 1: View Of Front Transmission Mount Bolts
    GM471753Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the front transmission mount and install the bolts.

    Tighten:  Tighten the bolts to 130 N.m (96 lb ft).

    2. Fig 2: View Of Front Bracket To Cradle Bolts
    GM471743Courtesy of GENERAL MOTORS CORP.
  2. Position the lower transmission mount bracket and install the bolts.

    Tighten:  Tighten the bolts to 120 N.m (89 lb ft).

    3. Fig 3: View Of Mount Through Bolt (Front)
    GM471740Courtesy of GENERAL MOTORS CORP.
  3. Install the transmission mount through bolt.

    Tighten:  Tighten the through bolt to 75 N.m (55 lb ft).

  4. Remove the jackstand and the wood block.
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals