Assembly Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Am and 2004 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Power Steering Pump Flow Control Valve Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Install the flow control spring (2) to the hydraulic pump housing assembly (1).
Install the control valve assembly (3).
Lubricate the new O-ring seal (4) with power steering fluid.
Install the O-ring seal (4) on to the O-ring union fitting (5).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).
Tighten: Tighten the O-ring union fitting to 75 N.m (55 lb ft).