Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Cargo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System - 6.0L (CNG) - Introduction) >> Repair Instructions >> Fuel Tank Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the shield around the tank frame.
    2. Fig 1: Fuel Tank Shield
    GM893889Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. While an assistant holds the shield in place, loosely install the shield retaining bolts.

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft).

  3. Install the weight distributing hitch if equipped. Refer to WEIGHT DISTRIBUTION HITCH REPLACEMENT in Frame and Underbody.
scientia non olet · About Mike's Workshop Manuals