Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Chevy Express G3500, Van Passenger Extended >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 4.8L, 5.3L, And 6.0L - Introduction >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

IMPORTANT: Take care when handling the mass air flow/ intake air temperature (MAF/IAT) sensor. Do not dent, puncture, or otherwise damage the honeycell located at the air inlet end of the MAF/IAT. Do not touch the sensing elements or allow anything including cleaning solvents and lubricants to come in contact with them. Use a small amount of a non-silicone based lubricant, on the air duct only, to aid in installation. Do not drop or roughly handle the MAF/IAT sensor.
  1. Disconnect the MAF/IAT sensor electrical connector.
  2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  3. Loosen the clamp securing the MAF/IAT sensor to the air cleaner duct.
  4. Remove the MAF/IAT sensor bolts from the air cleaner assembly.
  5. Remove the MAF/IAT from the air cleaner.
scientia non olet · About Mike's Workshop Manuals