Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2005 GMC Safari and 2005 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Control Valve Assembly
    GM580317Courtesy of GENERAL MOTORS CORP.
  1. Install the flow control spring (5), if removed from the pump housing (1).
  2. Lubricate the new O-ring seal (3) with power steering fluid.
  3. Install the O-ring seal (3) onto the connector and fitting assembly (2).
  4. Install the control valve assembly (4).
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the connector and fitting assembly (2).

    Tighten:  Tighten the connector and fitting assembly to 75 N.m (55 lb ft).

scientia non olet · About Mike's Workshop Manuals