Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Module Replacement (Front) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Safari and 2005 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Wiper Motor Module Cover Screws
    GM348761Courtesy of GENERAL MOTORS CORP.
  1. Install the circuit board and terminal module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the cover and 3 screws.

    Tighten:  Tighten the screws to 2.6 N.m (23 lb in).

  3. Install the wiper motor electrical connector.
scientia non olet · About Mike's Workshop Manuals