Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.8L, 5.3L & 6.0L - Introduction) >> Repair Instructions >> Throttle Actuator Control (TAC) Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: I/P Wiring Harness Electrical Connector
    GM858196Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the instrument panel (I/P) harness electrical connector (2).
    2. Fig 2: View Of TAC Module Electrical Connector
    GM871922Courtesy of GENERAL MOTORS CORP.
  2. Release the red connector position assurance (CPA) retainer.
  3. Disconnect the engine wiring harness electrical connector (1).
    4. Fig 3: Throttle Actuator Control (TAC) Module Nuts
    GM855736Courtesy of GENERAL MOTORS CORP.
  4. Remove the throttle actuator control (TAC) module nuts.
  5. Remove the TAC module.
scientia non olet · About Mike's Workshop Manuals