Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Astro Van Cargo, AWD >> Repair and Diagnosis >> Steering >> Steering Linkage (Non-Rack & Pinion) >> Repair Instructions >> Connecting Rod Replacement (RWD) >> Installation Procedure

Installation Procedure

    Fig 1: Seating The Idler Arm Tapers
    GM689037Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Use the J 29193  in order to connect the connecting rod to the pitman arm ball stud. See Special Tools .

    Ensure that the seal is on the stud.

    Tighten:  Tighten the J 29193  to 54 N.m (40 lb ft) in order to seat the tapers.

    Remove the J 29193  . See Special Tools .

    2. Fig 2: View Of Connecting Rod Components (RWD)
    GM414584Courtesy of GENERAL MOTORS CORP.
  2. Install the new prevailing torque nut (2) to the pitman arm (3) ball stud.

    Tighten:  Tighten the nut to 62 N.m (48 lb ft).

  3. Use the J 29193  in order to install the connecting rod (1) ball stud to the relay rod (4). See Special Tools .

    Ensure that the seal is on the stud.

    Tighten:  Tighten the J 29193  to 54 N.m (40 lb ft) in order to seat the tapers.

  4. Remove the J 29193  . See Special Tools .
  5. Install the new prevailing torque nut (5) to the ball stud.

    Tighten:  Tighten the nut to 47 N.m (35 lb ft).

  6. Lower the vehicle.
  7. Adjust the toe-in. Refer to Front Toe Adjustment in Wheel Alignment.
scientia non olet · About Mike's Workshop Manuals