Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Repair Instructions >> Roller Bracket Replacement - Lower >> Installation Procedure

Installation Procedure

    Fig 1: View Of Sliding Door Lower Roller Bracket
    GM319983Courtesy of GENERAL MOTORS CORP.
  1. Install the sliding door lower roller bracket to the lower track.
    2. Fig 2: View Of Sliding Door Catch
    GM319980Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the sliding door catch with reinforcement channel bolt at the sliding door lower track.

    Tighten:  Tighten the reinforcement channel bolt to 12 N.m (106 lb in).

  3. Align the sliding door lower roller bracket to the grease pencil marks on the sliding door.
    4. Fig 3: Locating Sliding Door Bracket Bolts
    GM319985Courtesy of GENERAL MOTORS CORP.
  4. Install the sliding door lower roller bracket bolts.

    Tighten:  Tighten the lower roller bracket bolts to 25 N.m (18 lb ft).

  5. Remove the support from the sliding door.
  6. Install the front edge of the sliding door inner trim panel to the sliding door.
scientia non olet · About Mike's Workshop Manuals