Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Repair Instructions >> Roller Bracket Replacement - Center >> Removal Procedure

Removal Procedure

  1. Open the sliding door in order to gain access to the center roller bracket pin.
  2. Support the rear of the sliding door.
    3. Fig 1: Locating Center Roller Bracket Pin
    GM319964Courtesy of GENERAL MOTORS CORP.
  3. Remove the pin from the center roller bracket.
  4. Position the center roller bracket to the front radius of the sliding door center track.
  5. Release cable tension. Refer to Cable Tension Adjustment - Sliding Door (Regular Method) , Cable Tension Adjustment - Sliding Door (Alternate Method)  or Cable Tension Adjustment - Sliding Door (With RPO E59) .
  6. Remove the cable from the rear roller bracket.
    7. Fig 2: View Of Center Roller Bracket
    GM319968Courtesy of GENERAL MOTORS CORP.
  7. Lift the center roller bracket upwards and remove the bracket from the center track.
    8. Fig 3: View Of Cable Ends
    GM319975Courtesy of GENERAL MOTORS CORP.
  8. Detach the cable ends (power sliding door only).
scientia non olet · About Mike's Workshop Manuals