Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Repair Instructions >> Cruise Release Switch Replacement >> Installation Procedure

Installation Procedure

  1. Install the cruise control release switch electrical connector.
    2. Fig 1: View Of Cruise Control Release Switch At Retainer
    GM882912Courtesy of GENERAL MOTORS CORP.

  2. With the electrical connector index notch at the 10 o'clock position, install the cruise control release switch to the retainer.

    3. IMPORTANT: Do NOT move or push the brake pedal.
  3. Slide the switch into the retainer until the plunger is fully depressed into the barrel.
    4. Fig 2: View Of Cruise Release Switch
    GM882916Courtesy of GENERAL MOTORS CORP.
  4. Rotate the cruise control release switch clockwise until the travel stop has been reached (approximately 60 degrees). The electrical connector index notch should now be at the 12 o'clock position.
  5. Ensure that the cruise control system operates properly.
  6. Install the left side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
scientia non olet · About Mike's Workshop Manuals