Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System And Washer System >> Repair Instructions >> Wiper Module Cover Replacement >> Installation Procedure

Installation Procedure

  1. Position the wiper drive system module cover to the pinchweld flange.
    Fig 1: View Of Wiper Module Cover
    GM776385Courtesy of GENERAL MOTORS CORP.
  2. Install the wiper drive system module cover to the pinchweld flange, pressing down until fully seated.
  3. Install the hood rear seal to the pinchweld flange.
  4. Close the hood.
scientia non olet · About Mike's Workshop Manuals