Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Tracker RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case) >> Repair Instructions >> Shift Lever Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the gearshift control lever into the gearshift lever case by pushing down on the shift control lever pivot and turning clockwise 90 degrees 1/4 turn and releasing.
  2. Install the gearshift lever case boot to the gearshift lever case. Secure the boot with the 1 clamp.
  3. Install the gearshift control lever boot (1) and the boot cover onto the gearshift control lever (2). Secure the boot and the cover with the 6 screws.
    4. Fig 1: View Of Gearshift Control Lever Boot & Control Lever
    GM167066Courtesy of GENERAL MOTORS CORP.
  4. Install the gearshift control lever knob (1) onto gearshift control lever. Secure the knob with the 1 screw.
  5. Install the front console box to the floor. Secure the front console box with the 2 plastic retainers and the 2 screws.
  6. Install the rear console box to the floor. Secure the rear console box with the 2 plastic retainers and the 2 screws.
    7. Fig 2: View Of Gearshift Control Lever Knob
    GM167065Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals