Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Tracker RWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Back Frame Replacement - Front (Driver Side) >> Installation Procedure

Installation Procedure

    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the seat back cushion pad and frame (1) to the front seat. Secure the frame to each seat adjuster (3) with the 2 mounting bolts (2).

    Tighten:  Tighten the front seat back cushion mounting bolts to 35 N.m (25 lb ft).

    2. Fig 1: View Of Seat Recliner & Seat Belt Buckle
    GM479521Courtesy of GENERAL MOTORS CORP.
  2. Roll the seat back cushion cover (1) onto the seat back cushion pad and frame.
  3. Secure the J-retainer (2) on the bottom of the seat back cushion cover (1) around the seat adjuster lateral rod (3).
  4. Install the front seat head restraint and the guides. Refer to Head Restraint Replacement - Front Seat .
  5. Install the armrest. Refer to Armrest Replacement .
  6. Install the lumbar support knob. Refer to Lumbar Support Knob Replacement .
  7. Install the front seat inner adjuster finish cover. Refer to Seat Adjuster Track Cover Replacement - Front Inner .
  8. Install the front seat. Refer to Seat Replacement - Front Bucket .
    9. Fig 2: View Of Seat Back Cushion, Adjuster Lateral Rod & J-Retainer
    GM489097Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals