Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 4L60-E/4L65-E - Introduction, Service & Replacement >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of VSS, Bolt & O-Ring Seal
    GM481937Courtesy of GENERAL MOTORS CORP.
  1. Install the O-ring seal (3) on the vehicle speed sensor (1).
  2. Coat the O-ring seal (3) with a thin film of transmission fluid.
  3. Install the vehicle speed sensor (1) into the transmission case.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolt (2).

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  5. Connect the wiring harness electrical connector to the vehicle speed sensor.
  6. Refill the fluid as required.
scientia non olet · About Mike's Workshop Manuals