Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 4L60-E/4L65-E - Introduction, Service & Replacement >> Repair Instructions >> 2-4 Servo >> Installation Procedure

Installation Procedure

  1. Install new seals on the servo pistons and the servo cover.
    2. Fig 1: View Of 2-4 Servo
    GM642523Courtesy of GENERAL MOTORS CORP.
  2. Install the 2-4 servo assembly into the transmission.
  3. Install the J 29714-A  . See Special Tools and Equipment .
    4. Fig 2: Compressing The Servo Cover Using J 29714-A
    GM14478Courtesy of GENERAL MOTORS CORP.
  4. Tighten the bolt in order to compress the servo cover.
  5. Install the servo cover retaining ring.
  6. Remove the J 29714-A  from the oil pan flange. See Special Tools and Equipment .
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the oil pan bolt.

    Tighten:  Tighten the oil pan bolt to 11 N.m (97 lb in).

    8. Fig 3: View Of Transmission Heat Shield Bolts & Shield
    GM394459Courtesy of GENERAL MOTORS CORP.
  8. Install the heat shield.
  9. Install the two bolts securing the transmission heat shield to the transmission.

    Tighten:  Tighten the bolts to 17 N.m (13 lb ft).

  10. Install the exhaust pipe assembly. Refer to Catalytic Converter Replacement in Engine Exhaust.
  11. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  12. Remove the transmission jack.
  13. Lower the vehicle.
  14. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About Mike's Workshop Manuals