Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> External Pages >> Different car >> Section 686 (Engine Control System - 5.3L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Sight Shield
    GM1231427Courtesy of GENERAL MOTORS CORP.
  1. Loosen the fasteners from the intake manifold sight shield.
  2. Remove the sight shield.
  3. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
    4. Fig 2: Identifying MAP Sensor
    GM260159Courtesy of GENERAL MOTORS CORP.
  4. Remove the MAP sensor (1) from the intake manifold.
scientia non olet · About Mike's Workshop Manuals