Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> S10 Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2004 GMC Safari and 2004 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flow control spring (5), if removed from the pump housing (1).
    Fig 1: View Of Power Steering Pump Control Valve Assembly
    GM580317Courtesy of GENERAL MOTORS CORP.
  2. Lubricate the new O-ring seal (3) with power steering fluid.
  3. Install the O-ring seal (3) onto the connector and fitting assembly (2).
  4. Install the control valve assembly (4).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the connector and fitting assembly (2).

    Tighten:  Tighten the connector and fitting assembly to 75 N.m (55 lb ft).

scientia non olet · About Mike's Workshop Manuals