Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Monte Carlo LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement (L36) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical 3.8L.
  2. Disconnect the MAP sensor electrical connector.
  3. Carefully release the locking tabs holding the MAP (1) sensor to the PCV valve cover (2) just enough to remove the MAP sensor.
  4. Pull the MAP sensor straight out of PCV valve cover.
    5. Fig 1: Removing MAP Sensor (L36)
    GM12346Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals