Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Monte Carlo LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Knock Sensor (KS) 1 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer toLifting and Jacking the Vehicle in General Information.
  2. Drain the cooling system. Refer toDraining and Filling Cooling System in Engine Cooling.
  3. Disconnect the knock sensor electrical connector (2).
  4. Remove the knock sensor (1).
    5. Fig 1: Removing KS Sensor (1)
    GM892627Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals