Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4T65-E (Introduction, Service & Replacement) >> Repair Instructions >> Torque Converter Cover Replacement >> Installation Procedure

Installation Procedure

  1. Install the torque converter covers.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the torque converter cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 1: Removing/Installing Torque Converter Covers
    GM631009Courtesy of GENERAL MOTORS CORP.
  3. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals