Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4T65-E (Introduction, Service & Replacement) >> Repair Instructions >> Output Shaft Replacement >> Installation Procedure

Installation Procedure

  1. Install the drive axle retainer rings (509) to the output shaft (510).
    2. Fig 1: Drive Axle Retainer Rings & Output Shaft
    GM214419Courtesy of GENERAL MOTORS CORP.
  2. Hold the front differential carrier in place and carefully install the output shaft (510) to the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
  3. Install the case extension housing. Refer to Case Extension Housing Replacement .
  4. Install the left drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
scientia non olet · About Mike's Workshop Manuals