Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System 3.4L (Introduction)) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the exhaust gas recirculation (EGR) valve electrical connector.
  2. Remove the EGR pipe bolt and carefully pull the pipe assembly back.
  3. Remove the EGR valve bolts.
  4. Remove EGR valve.
  5. Remove the EGR valve gasket.
  6. Clean and inspect the EGR valve gasket mating surfaces.
    7. Fig 1: Removing EGR Valve
    GM507392Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals