Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Cellular Communication Systems) >> Schematic and Routing Diagrams >> Cellular Communication Schematic Icons

Cellular Communication Schematic Icons

WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Cellular Communication Schematic Icons

Icon Icon Definition
GM296880Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Twisted wires provide an effective "shield" that helps protect sensitive electronic components from electrical interference. In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted wires shown.
  • The wires must be twisted a minimum of 9 turns per 31 cm (12 in) as measured anywhere along the length of the twisted triplet. The outside diameter of the twisted triplet must not exceed 5.8 mm (0.2 in)
  • The drain wire must be wrapped around the twisted triplet a minimum of 3 turns for the length of the twisted triplet.
  • The twisted triplet and the drain wire must be continuously covered by shield tape aluminum side inward. The shield tape must be covered with tape.
  • Tubing must be against the back of the terminal insulation wings and secured at the other end with tape.
scientia non olet · About Mike's Workshop Manuals