Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4T65-E (Introduction, Service & Replacement) >> Repair Instructions >> Floor Shift Control Replacement >> Removal Procedure

Removal Procedure

  1. Remove the Console Trim Plate. Refer to Trim Plate Replacement - Front Floor Console (Monte Carlo) or Trim Plate Replacement - Front Floor Console (Impala) or Console Replacement - Front Floor (Impala) or Console Replacement - Front Floor (Monte Carlo) in Instrument Panel, Gauges and Console.
  2. Remove the console wiring harness.
  3. Remove the console shift control wiring harness.
    4. Fig 1: Removing Console Shift Control Wiring Harness
    GM161196Courtesy of GENERAL MOTORS CORP.
  4. Remove the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement .
  5. Remove the park/lock cable. Refer to Park Lock Cable Replacement .
  6. Disconnect the lightbulb and the retainer from the shifter.
  7. Remove the console shift control retaining nuts.
  8. Remove the console shift control assembly from the vehicle.
    9. Fig 2: Console Shift Control Assembly
    GM161200Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals