Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Impala Base, 3.4 E >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Throttle Body Air Inlet Screen Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the throttle body air inlet screen (2).
  2. Install the snap ring (3).
  3. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
    4. Fig 1: Installing Throttle Body Air Inlet Screen
    GM180140Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals