Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Impala Base, 3.4 E >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement (L67) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical 3.8L.
  2. Disconnect the MAP sensor electrical connector and the vacuum hose.
  3. Remove the manifold absolute pressure (MAP) sensor screws.
  4. Remove the MAP sensor.
    5. Fig 1: Removing MAP Sensor (L67)
    GM12345Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals