Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Impala Base, 3.4 E >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the exhaust gas recirculation (EGR) valve electrical connector.
  2. Remove the EGR valve nuts (4).
  3. Remove the EGR valve (1).
  4. Remove the gasket (2) from the EGR valve adapter.
  5. Clean the EGR valve gasket mating surfaces.
    6. Fig 1: EGR Valve & Components
    GM12312Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals