Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Impala Base, 3.4 E >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System 3.4L (Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement (24X) >> Removal Procedure

Removal Procedure

  1. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement in Engine Mechanical - 3.4L.
  2. Note the routing of the crankshaft position (CKP) sensor harness before removal.
  3. Remove the CKP sensor harness retaining clip bolt (4).
  4. Remove the CKP sensor harness retaining clip (3).
  5. Disconnect the CKP sensor.
  6. Remove the CKP sensor bolts (4).
  7. Remove the CKP sensor (1).
    8. Fig 1: Removing CKP Sensor (24X)
    GM14714Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals