Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Bracket Replacement >> Removal Procedure

Removal Procedure

    Fig 1: EBCM Harness Connector & Bracket
    GM707000Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition switch to the OFF position.
  2. Loosen the two insulator nuts (1).
    3. IMPORTANT: Do not kink or bend the brake lines when moving the EBCM/BPMV assembly.
  3. Lift the EBCM/BPMV assembly out of the bracket and support.
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    5. Fig 2: Steering Gear Nut & BPMV Bracket
    GM692288Courtesy of GENERAL MOTORS CORP.
  5. Remove the two BPMV bracket bolts.
  6. Remove the steering gear nut and bolt.
  7. Remove the BPMV bracket.
scientia non olet · About Mike's Workshop Manuals