Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Classic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement >> Repair Instructions >> Low/Reverse Servo Assembly Replacement >> Installation Procedure

Installation Procedure

  1. Assemble the low/reverse servo. Refer to Low and Reverse Servo Assemble and Installation in Automatic Transmission Transaxle Unit Repair Manual.
    2. Fig 1: View of Servo, Cover Bolts, & Spring
    GM588858Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the low/reverse band servo cover bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  3. Install the oil feed pipe. Refer to Oil Feed Pipes Replacement .
  4. Install the oil filter and pan. Refer to Oil Filter and Seal Replacement .
  5. Lower the vehicle.
  6. Connect the negative battery cable.
  7. Fill the transmission. Refer to Fluid Capacity Specifications .
  8. Inspect the transmission fluid level. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About Mike's Workshop Manuals