Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Cavalier Base, 4D Sedan, 2.2 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Ignition Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn OFF the ignition.
  2. Remove the accelerator cable from the bracket.
  3. Remove the accelerator cable bracket bolt.
  4. Remove the accelerator cable bracket.
  5. Disconnect the ignition control module (ICM) harness connector.
    Fig 1: View Of Ignition Control Module
    GM783965Courtesy of GENERAL MOTORS CORP.
  6. Remove the ICM retaining screws.
  7. Remove the ICM from the ignition coil housing.
scientia non olet · About Mike's Workshop Manuals