Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Module Replacement (Front) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Safari and 2004 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the circuit board and terminal module.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the cover and 3 screws.

    Tighten:  Tighten the screws to 2.6 N.m (23 lb in).

    Fig 1: View Of Front Wiper Motor Module Cover Screws
    GM348761Courtesy of GENERAL MOTORS CORP.
  3. Install the wiper motor electrical connector.
scientia non olet · About Mike's Workshop Manuals