Wiring Systems - Specifications, Component Views And Connector End Views

• Diagnostic Information and Procedures
  • Electrical Symbols
    • Notes
    • Wires with Tracers
  • General Electrical Diagnosis Procedures
    • Basic Knowledge Required
  • Checking Aftermarket Accessories
  • Circuit Testing
  • Using Connector Test Adapters
  • Probing Electrical Connectors
    • Notes
    • Frontprobe
    • Backprobe
  • Troubleshooting with a Digital Multimeter
  • Troubleshooting with a Test Lamp
  • Using Fused Jumper Wires
  • Measuring Voltage
  • Measuring Voltage Drop
  • Measuring Frequency
  • Testing for Continuity
    • Notes
    • With a DMM
    • With a Test Lamp
  • Testing for Short to Ground
    • Notes
    • With a DMM
    • With a Test Lamp
    • Fuse Powering Several Loads
  • Testing for a Short to Voltage
  • Testing for Intermittent Conditions and Poor Connections
    • Notes
    • Testing for Proper Terminal Contact
      • Notes
      • Round Wire Connectors
      • Flat Wire (Dock and Lock) Connectors
  • Inducing Intermittent Fault Conditions
    • Notes
    • Salt Water Spray
    • High Temperature Conditions
    • Low Temperature Conditions
  • Testing for Electrical Intermittents
  • Scan Tool Snapshot Procedure
  • Circuit Protection - Fuses
  • Circuit Protection - Circuit Breakers
  • Circuit Protection - Fusible Links
    • Notes
    • Repairing a Fusible Link
  • Wiring Repairs
  • Repairing Damaged Wire Insulation
  • Flat Wire Repairs
  • Heated Oxygen Sensor (HO2S) Wiring Repairs
  • Splicing Copper Wire Using Splice Clips
  • Splicing Copper Wire Using Splice Sleeves
  • Splicing Twisted or Shielded Cable
  • Splicing Inline Harness Diodes
  • SIR/SRS Wiring Repairs
    • Connector Repair
    • Wire Repair
  • Connector Repairs
  • Connector Position Assurance Locks
  • Terminal Position Assurance Locks
  • Push to Seat Connectors
    • Terminal Removal
    • Terminal Repair
    • Reinstalling Terminal
  • Pull to Seat Connectors
    • Terminal Removal
    • Terminal Repair
    • Terminal Installation
  • Micro-Pack 100W Connectors
    • Terminal Removal Procedure
    • Terminal Repair Procedure
  • Micro .64 Connectors
    • Tools Required
    • Terminal Removal Procedure
    • Terminal Repair Procedure
  • Weather Pack Connectors
  • Repairing Connector Terminals
• Schematic and Routing Diagrams
  • Power and Grounding Schematic Icons
  • Power Distribution Schematics
  • Ground Distribution Schematics
  • Harness Routing Views
• Component Locator
  • Master Electrical Component List
  • Electrical Center Identification Views
    • Fuse Block - Underhood Label
    • Fuse Block - Underhood
    • Fuse Block - I/P Label
    • Fuse Block - I/P Wire Entry
  • Inline Harness Connectors
    • C101
    • C102
    • C104
    • C106
    • C107
    • C113
    • C114
    • C201
    • C202
    • C203
    • C204
    • C205
    • C210
    • C211
    • C212
    • C213
    • C214
    • C351
    • C361
    • C371
    • C381
    • C401 (Hatchback)
    • C401 (Notchback)
    • C402 (Hatchback)
    • C402 (Notchback)
    • C403 (Hatchback)
    • C404 (Hatchback)
    • C415 (Hatchback)
    • C415 (Notchback)
    • C416 (Hatchback)
    • C416 (Notchback)
    • C417 (Hatchback)
    • C417 (Notchback)
  • Splice Pack Connectors
    • SP101 (1.2L)
    • SP101 (1.4L, 1.5L, 1.6L)
    • SP201 (1.2L)
    • SP201 (1.4L, 1.5L, 1.6L)
    • SP202 (LHD)
    • SP202 (RHD)
• Repair Instructions
  • Relay Replacement (Within an Electrical Center)
    • Tools Required
    • Removal Procedure
    • Installation Procedure
  • Relay Replacement (Attached to Wire Harness)
    • Removal Procedure
    • Installation Procedure
• Special Tools and Equipment
  • Special Tools