Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Avalanche 1500, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 8.1L (Introduction)) >> Repair Instructions >> Intake Air Resonator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Air Cleaner Resonator Outlet Duct
    GM858226Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner resonator outlet duct.
  2. Install the air cleaner resonator outlet duct to the throttle body.
  3. Align the stud on the throttle body with the screw on the clamp.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the air cleaner resonator outlet duct clamp at the throttle body.

    Tighten:  Tighten the clamp to 4 N.m (35 lb in).

    5. Fig 2: View Of Intake Air Resonator Outlet Duct
    GM858228Courtesy of GENERAL MOTORS CORP.
  5. Install the air cleaner resonator outlet duct to the MAF/IAT sensor.
  6. Tighten the air cleaner resonator outlet duct clamp at the MAF/IAT sensor.

    Tighten:  Tighten the clamp to 4 N.m (35 lb in).

scientia non olet · About Mike's Workshop Manuals