Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2004 >> Astro Van Cargo, AWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Repair Instructions >> Seat Belt Retractor Replacement - Left Front >> Installation Procedure

Installation Procedure

  1. Install the retractor to the vehicle.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retractor bolt to the pillar.

    Tighten:  Tighten the retractor bolt to the pillar to 53 N.m (39 lb ft).

  3. Install the electrical connectors.
  4. Install the body side front lower molding. Refer to Trim Panel Replacement - Body Side Front Lower .
  5. Install the left inside garnish molding. Refer to Garnish Molding Replacement - LF Lock Pillar .
  6. Install the bolt retaining the shoulder belt guide to the adjuster bracket.

    Tighten:  Tighten the shoulder belt retaining bolt to 30 N.m (22 lb ft).

    Fig 1: Locating Shoulder Belt Guide Adjuster Bracket Retaining Bolt - Left Front
    GM361863Courtesy of GENERAL MOTORS CORP.
  7. Install the cover to the shoulder belt guide.
  8. Install the seat belt to the seat belt guide located on the side of the bucket seat.
  9. Slide the front seat back in position.
scientia non olet · About Mike's Workshop Manuals