Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2003 >> Venture Base, Van Passenger Extended >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Switch Replacement - Power >> Installation Procedure

Installation Procedure

  1. Connect the adjuster switch electrical connector.
  2. Install the adjuster switch to the finish cover.
  3. Install the finish cover to the seat adjuster.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the finish cover screws.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  5. Connect the front seat pretensioner electrical connector.
  6. Connect the front seat SIR module electrical connector.
    Fig 1: Installing Adjuster Switch To Finish Cover
    G01531951Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals