Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2003 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Lower Control Arm Bushings Replacement >> Installation Procedure

Installation Procedure

Important:  Install the lower control arm vertical bushing in the original position in order to maintain the original vehicle ride, handling and road feel.

  1. Align the flat edge of the bushing flange to the mark in the control arm (1). Ensure that the flat edge of the bushing flange is 30 degrees (2) from the centerline of the lower control arm. Ensure that the thin slot in the bushing is facing outboard.
  2. Insert the bushing into the control arm.
    Fig 1: Installing Lower Control Arm Vertical Bushing In Original Position
    G01483174Courtesy of GENERAL MOTORS CORP.

    Important:  Apply J 23444-A, or equivalent high pressure lubricant, to the threads of the J 21474-27. 

  3. Assemble the following bushing installation tools as shown:
    • J 21474-27  Puller Bolt
    • J 21474  Control Arm Bushing Installer
    • J 21474-5  Bushing Receiver
    • J 21474-4  Nut
  4. Tighten the J 21474-4  until the bushing is fully seated in the control arm.
  5. Disassemble the bushing installation tools.
  6. Install the lower control arm. Refer to LOWER CONTROL ARM REPLACEMENT   . 
    Fig 2: Inserting Bushing Into Control Arm
    G01483175Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals